I just had this problem on my MGA, although I was recovering from a
catastrophic failure. If it is too loose, look carefully to see if the
rocker arm is bent. Mine didn't look obvious unless held immediately
next to a good one. I don't know why it bent (it was not on the
cylinder that dropped the valve) but it certainly was bent.
Tom Gunderson wrote:
> I cannot adjust the #8 valve after the head had been machined. Any ideas?
>
> Sent from my iPhone
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as james.f.juhas@snet.net
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
[demime 1.01d removed an attachment of type text/x-vcard which had a name of
james_f_juhas.vcf]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|