Re: [Mgs] Crankshaft problem

[Paul Root <ptrmgb@gmail.com>]

It should work fine. Be sure to clean up the mating edges very  
carefully.


Merry Christmas.

On Dec 24, 2008, at 1:08 PM, mg.carma wrote:

> Well folks,
> I recently took a 1600 block apart and I THINK I have found out why
> the engine was not moving as freely as I wished.
>
> Please advise if you think that I can remedy this problem with the
> solution pictured.
>
> Thanks and Merry Christmas everyone!
>
> 
>http://s5.photobucket.com/albums/y165/mgcarma/1600%20motor/?action=view&current=DSCN2525.jpg
>
> Cheers
> Kevin
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
>
> You are subscribed as ptrmgb@gmail.com
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net  http://www.team.net/donate.html




Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs

http://www.team.net/archive