| To: | <cyberemp@comcast.net>, "MG LIST" <mgs@autox.team.net> |
|---|---|
| Subject: | Re: [Mgs] transmission input shaft info |
| From: | "Paul Hunt" <paul.hunt1@blueyonder.co.uk> |
| Date: | Fri, 12 Sep 2008 09:18:30 +0100 |
FWIW I've measured my alignment tool, which I have just used to replace a clutch and it was a snug fit, at 0.967" maximum diameter and 23 splines. PaulH. ----- Original Message ----- Can anyone confirm or deny the input shaft of our MGs? For the 4 syncro unit I'm working with diamiter measurements of 15/16" 22 spline _______________________________________________ Support Team.Net http://www.team.net/donate.html Mgs@autox.team.net http://autox.team.net/mailman/listinfo/mgs http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Mgs] carb flooding, Paul Hunt |
|---|---|
| Next by Date: | [Mgs] Hurricane Ike, Dan DiBiase |
| Previous by Thread: | Re: [Mgs] transmission input shaft info, Dodd, Kelvin |
| Next by Thread: | [Mgs] carb flooding, Bernd |
| Indexes: | [Date] [Thread] [Top] [All Lists] |