Is it a bolt up fit or is a kit needed?
>
>
> Well, I just pulled it out of storage, and I see that it is a
> Nissan/Datsun
> Roadster engine!!!!! It will fit the MGB since it is basically a
> copy, but
> it has a head modification that requires a different heater valve,
> and I'd
> have to fabricate a blanking plate to cover a big hole in the
> engine block
> (I have no idea what that opening was for). I'm reluctant to mess.
> So, I
> thought I'd seek some fellow motorhead opinions. Anybody want an
> MG "copy"
> engine made in Japan? The metallurgy is probably better!
>
>
>
> Any ideas would be appreciated, I'd hate to see it go to the
> recycler, but
> iron is about ten cents a pound, and that may be all I can get out
> of it.
> I'll check for Datsun 1600/2000 member groups, but only 30,000 of
> these were
> made.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|