That's what you do on the MGB, use a drift through the hub to push them out
working round the circumference.
PaulH.
----- Original Message -----
How do I remove the bearings from the front hubs on an MGA? I assume
each bearing pulls out the sleeve in the center prevents using some
kind of puller. The only method I can think of is to get a punch on
the inner edge and try to tap it out.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|