Hi Ed,
Kelvin gave you the answer you need, but there can be a bit more to
the story----
It's possible to do some mix&matching of water pumps on these
engines. I had one, for example, with a "long" pump on an 18 V and metal
fan. When I ordered a new pump at rebuild time, the right (short) pump
for the 18V, I found that the pulley used on the long pump would rub on
the pump toward the engine, and so required a spacer to move it forward
for clearance. Well and good, except that the "correct" spacer then
caused misalignment of the belt grooves. I couldn't find a correct pulley
for this pump (rushing to get the car running for some club event) so I
turned off the rear (engine side) pulley groove and made a spacer of 1/4"
(maybe 3/16) aluminium that fits inside the pulley I had. The spacer
caused the grooves to align.
That makes me a DPO also, since it works fine but it's not per the
book.
You may find mix & match in your car too.....
Bob
On Tue, 17 Jun 2008 13:07:45 -0400 "Ed Woods" <fogbro1@comcast.net>
writes:
> Hello again,
>
> The question this time is: is there supposed to be a fan spacer
> between the
> water pump pulley and the fan on a '72 MGB with the 18V engine? It
> uses the
> six bladed metal fan.
>
> The length of the four bolts that secure the fan indicate that
> there's a
> spacer required, but I've torn the place apart and cannot find one.
>
> Thanks,
>
> Ed Woods
____________________________________________________________
Save on Moving Supplies. Click Here!
http://thirdpartyoffers.juno.com/TGL2141/fc/Ioyw6i3oij8uk2w2jxjEJIn4CKGz4MurL49Vk4Xv47gdy2JWrZKehv/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|