Hey Gang,
Some time ago I asked the size of the thin-wall socket
needed to remove the axle nut on the MGB's rear axle.
I believe that the size is 1-5/8" but I need to verify
that before buying a socket. Is that size correct? I
need to remove the hub to replace the oil seal (then
rebuild the brakes).
Second question; anyone know of a source for these
sockets? I have looked in all the usual places but I
have not found the 1-5/8" size.
All advice is appreciated.
rick
'08 M-B C300
'03 L-R Discovery
'96 BMW 740iL
'79 Ferrari 308GTB
'70 MGB Split-bumper Tourer
'61 M-B 180b Saloon
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|