Paul,
More to last week's writings about damper springs:
Jim Taylor, retired design engineer, wrote this for the Jaguar Club.
www.jcna.com/library/tech0006.html
A piston spring combined with the weight of the aluminium piston
provides the necessary downward force to maintain essentially a constant
pressure loss (depression) at the throat of the carburettor. The springs
are initially color coded with paint for identification. The paint
disappears with time. Common piston springs are as follows:
Code Force in Oz
@height
Blue 2.5 oz
2 5/8 inch
Red 4.5 oz
2 5/8 inch
Yellow 8.0 oz
2 3/4 inch
Green 12.0 oz
3 inch
Red & Green 11.25 oz
3 7/8 inch
It is difficult to identify springs visually since ones with the same
load rating may have different free lenghts, different wire diameter, and
different number of coils. The springs may also sag slightly with age
and use. To identify and check for proper specification I have made
cylindrical weights from aluminium bar stock corresponding to the above
table. I put the spring in a glass tube with the correct weight on top
of it and measure the compressed height. If the spring is too tall it
must be replaced. If it is not over 1/2" too short it usually can be
stretched. Springs can be brough back exactly to spec and matched with
each other. A squirt from a can of paint will serve for future
identifcation.
Jim's idea of using a weight and keeping the spring contained in a
glass tube is likely to be more accurate than the way I did it ( before I
lost my table of spring heights). I marked a dowel with the height, then
held spring with dowel inside on a scale, pressed down on the spring with
the specified force and read the height off the marked dowel.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|