Rick:
It's pressed in.
There should be a threaded rod sticking out of the center. I think 5/16
fine.
You can make a pulling tool out of a 5/16" spacer or Moss does have a
puller available if you plan on doing this again.
Worst case, do what thousands of DPO have done and use vice grips.
http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=53723
Kelvin Dodd
> -----Original Message-----
> From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net]
On
> Behalf Of Rick Lindsay
> Sent: Thursday, June 28, 2007 11:27 AM
> To: MGS
> Subject: [Mgs] front axle grease cups
>
> Hey Gang,
> I'm at work and the car and manuals are at home.
> Please share a bit of advice: My '70 B has wire wheels
> so it has spline hubs. How does the (front,
> obviously) grease cap come off? Is it press fit in?
> Screwed in? Magic?
>
> Thanks,
>
> rick
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|