mgs
[Top] [All Lists]

Re: [MGS] MGB tie rod end removal

To: "Councill, David" <dcouncill@msubillings.edu>
Subject: Re: [MGS] MGB tie rod end removal
From: Jim Juhas <james.f.juhas@snet.net>
Date: Wed, 06 Jun 2007 06:40:41 -0400
You can get the same thing from J.C.Whitney.  That's where I got mine.

Councill, David wrote:

>I had to check the archives but there is this one:
>http://www.thetoolwarehouse.net/shop/TA-61900.html
>
>It looks like it was a little more than two years ago, on this list,
>that Don Malling made a group purchase because this company had a
>minimum purchase of $50. He ordered quite a few and parted them out to
>the list at cost or maybe slightly above. I took one of them and have
>used it once so far. It did work quite a bit better than my slightly
>oversized pickle fork and was also non-destructive (I think I was just
>doing a gaiter replacement).
>
>David Councill
>67 BGT
>72 B
>01 Land Rover Discovery 2 SE7




<Prev in Thread] Current Thread [Next in Thread>