As long as it fits in one of the slots and not on top or across the other
lines and cables at an angle (which could well put undue pressure on one or
other of them when the strap is fitted), I would have thought it would be OK
even if not strictly correct.
----- Original Message -----
> Shaping the new fuel line was a chore as I don't have the old one to refer
> to. I've got it in but the problem is the bend and fit around the frame
> crossmember. There's a large rubber pad that the lines are held by and the
fuel line
> doesn't fit in it well. I can't get the fuel line in the proper spot in
the
> rubber pad because I didn't get the bends around the crossmember right. So
my
> question is, will it be okay if the line isn't properly seated in that
rubber pad
> or should I redo it?
|