Re: Rust proofing

["Larry Daniels" <ladaniels@sbcglobal.net>]

I was hoping someone would ask this question, but no luck.  Where do you 
pour the rust inhibitor of choice into the sills?  I see a hole in front of 
the sill plate on each side -- are their other places to make sure it gets 
all through the sills?  Any other places on the car this should be done?

Larry Daniels
79 MGB LE
72 Midget
58 Bugeye

"You only need two tools: WD-40 and Duct Tape. If it
doesn't move and should, use the WD-40. If it
shouldn't move and does, use the duct tape."