Re: Sizing correct bottm end bearings..

[Bob Howard <mgbob@juno.com>]

Jeremy,
    Bearings are marked on the back side if they are not STD (standard)
size, as .010, .020, etc, and sometimes STD bearings are marked as well. 
 
Bob


On Sun, 17 Apr 2005 12:19:16 -0400 Jeremy Loukinas
<Sunadmin@adelphia.net> writes:
> How do I go about sizing bottom end bearings ? I was getting a lower 
> rod 
> knock.. I pulled all the bearings and of course they all have some 
> brass 
> showing. How do i know which size to get?
> 
> STD? .10? .20 etc...
> 
> 
> Jeremy