Eric:
You are correct. The kit is designed after the eurospec cooler set up
that did not have an anti run on valve hose. Redirect the anti run on
hose elsewhere and use the two lower holes.
If you check out page 79 of the Clausager "Original MGB" there is a good
photo of how the hoses are attached to the coolant bottle.
We need to do some installation shots of this kit, but havn't had a
chance yet.
Kelvin Dodd
> -----Original Message-----
> From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net] On
Behalf
> Of Eric J Russell
> Sent: Thursday, March 10, 2005 3:00 PM
> To: mgs@autox.team.net
> Subject: oil cooler hose routing RB MGB ?
>
> I am adding an oil cooler to our 1978 RB MGB.
>
> What is the correct routing for the hoses through the radiator
bulkhead?
> (I
> have rubber grommets ready to install also.)
>
> There are three apertures located in the radiator bulkhead.
> Kinda looks like this:
> O
>
> O
> O
>
> Currently, the hose from the anti run-on valve is in the middle
aperture.
> I'm thinking the oil cooler hoses should go through the two lower
> apertures - they seem like a pair of holes. Should the hose from the
run-
> on
> valve should be in the upper hole? Except there is a bracket to hold
the
> run-on valve's hose near the middle aperture...
>
> Eric Russell
> STOC #2860
> Mebane, NC
|