I did this with the engine insitu.
Best is to have the starter motor out.
Beware when remounting the starter motor, that the ignition cap clamps are
kept upwards, otherwise you've to remove the starter again and get the
clamps up again.
Been there twice - nasty job.
Good to put the car on a car "bridge" for easy access.
Cheers,
Hans
'71 BGT
----- Original Message -----
From: "Scott Regel" <Scott.Regel@dpra.com>
To: <mgs@Autox.Team.Net>
Sent: Monday, December 13, 2004 7:40 PM
Subject: How hard is it to replace the clutch slave valve
> With the engine and transmission in place? Is this a pretty quick job?
> I know everyone says you should also replace the master too. But I am
> hoping that I just have a bad hose. Went to take the care out this
> weekend and almost put my foot thru the firewall. Crawled under the car
> and sure enough...fluid all over the mat.
>
>
>
> TIA
>
>
>
> Scott and Spot
>
> 76B
|