Yup, Paul is right. Excuse my little oversight.
Change "Remove Bulb" to:
"Dismount bulb but keep connected for load. Check voltage at the connector."
Barney Gaylord
1958 MGA with an attirtude
http://MGAguru.com
At 09:04 AM 11/29/04 +0000, Paul Hunt wrote:
>Not necessarily. If you remove the load and check for voltage with a
>typical voltmeter you could well see 12v displayed, even if there is a bad
>connection that will prevent the bulb glowing at all when
>connected. Always check voltages with the load connected.
>
>----- Original Message -----
>From: "Barney Gaylord" <barneymg@MGAguru.com>
>....
> > Remove the bulb. Check voltage in the harness connector. If you have
> power the bulb is bad. If no power start tracing back to prior
> connectors in the harness to see where you lost the connection.
|