My GT's badge on the rear hatch is also the flat plastic one.
Yes - I always wondered why this badge did fit so poorly.
So this poor quality stuff goes back over 10 years...
Although it never has been out in the rain etc. since I've put it on, it
shows some funny corrosion (Plastic?) - worm like mislooks.
Cheers,
Hans
'71 BGT
----- Original Message -----
From: <ATWEDITOR@aol.com>
To: <mgs@Autox.Team.Net>
Sent: Tuesday, November 23, 2004 4:26 PM
Subject: Re: Another weird electrical tale/Moss quality
> In a message dated 11/23/2004 10:14:39 AM Eastern Standard Time,
> ccrobins@ktc.com writes:
>
> Jay, does the replacement fuse holder seem to be good quality? Moss
> part?
>
>
>
> Yeah, from Moss and good quality. The fuse holders are tight and firmly
> secured. Much improvement from the old, beat to death old one.
>
> My comment on the current Moss quality line is that years ago when I had
> just got back into MGs with a roadster and went to replace that MG badge
> on the
> trunk lid I, too, had quality issues, which did not bode well for my early
> relationship with Moss. Since then I have been very well pleased, with
> the
> notable exception of some chrome parts. However, in Moss' defense, this
> also is
> an issue in the vintage Mustang world, so I am guessing that good quality
> chrome is simply hard to get. If it was available, but at a higher
> price, I
> would pay for it....better than replacing bumpers every 4-5 years.
>
> Jay
> 72B-GT
> 66 Mustang
|