Re-installing Oil Presure Relief Valve

["Steve Clifton" <sclifton@cfl.rr.com>]

Made the mistake of taking out the Oil Presure Relief Valve in my 72 MGB to
inspect.  Have had progressively less oil presure over the past year.
Getting it out was somewhat difficult, not much clearance with the exhaust
pipe in the way.  Problem now is getting it back in.  The spring presents so
much presure when trying to get the cap screwed back into the block.  Any
advice from the "been there, done that" would be appreciated.

Best Regards,

Steve C.
72 MGB