Yes, I noticed no mention of the shims in the original post. Do you have
those installed properly Bert?
donny v
78 MGB
In a message dated 12/31/2003 8:48:51 PM Eastern Standard Time,
lpalmer@roundaboutmanor.com writes:
> Bert,
>
> It's hard to tell exactly what is wrong without close inspection, but I
> would suspect one of 3 things:
>
> 1) The hubs have not been properly shimmed so the hub nut is not drawing up
> tight.
> 2) The bearing races in the hub are worn allowing sloppiness in the hub to
> bearings.
> 3) The bearings themselves are worn allowing free play in the hub.
>
> Cheers,
> Lew Palmer
|