Barrie,
What worked for me was to install the cable to the heater box while the
heater was out of the car. Then feed the cable back through from engine side
to the passenger side. Then slide the heater into position. A little KY
jelly on the dreaded rubber spacer block made an easy job of it.
Cheers,
Lew Palmer
-----Original Message-----
From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net] On Behalf
Of Barrie Robinson
Sent: Saturday, November 08, 2003 6:53 PM
To: mgs@autox.team.net; mgb-v8@autox.team.net
Subject: Installing the heater
I have read many times on the net about the (^$$@&%^^ heater
installation. I have a discourse from Mike Winney but I thirst for more
tips on installing that bastard of a flap cable !! I know someone other
than Mike gave some help but I cannot find it in my "MGB Tech" archive
mailbox,
Has anyone got any hard information rather than just suggestions? - My
suggestion is to dynamite the heater assembly and put in Vintage Air or
similar - but that is expensive!
Regards
Barrie
Barrie Robinson
barrier@bconnex.net
|