Glue? I did not use glue when I did my '65's seats, just the clips. This
was following Victoria British's excellent seat rebuilding
instructions....
--- "Telewest (PH)" <paul.hunt1@blueyonder.co.uk> wrote:
> The seat base cover should have flaps on all four sides. These are cut
> and
> wrapped around the frame tubes (glue applied first) and held in place
> with
> spring clips. The Porter Guide has a comprehensive section on seat
> recovering.
>
> PaulH.
>
> ----- Original Message -----
> From: "Peter C." <nosimport@mailbag.com>
> To: <mgs@autox.team.net>
> Sent: Tuesday, September 16, 2003 3:54 PM
> Subject: 67 B seat upholstery
>
>
> > How does the seat bottom cover get attached at the rear of the seat?
> How
> is
> > provision made for the seat back support bolt pads? Does one cut the
> cover
> > around them? What does the cover then clip to?
=====
Dan
The Garden State
'76 MGB Tourer - Driver - Nope, it's broke!
'65 MGB Tourer Project - Yep, still is....
NAMGBR #5-2328
http://mywebpages.comcast.net/dibiase/Working_MG_Gallery.html
__________________________________
Yahoo! SiteBuilder - Free, easy-to-use web site design software
|