The wrench won't fit WELL. It's an annoying job.
Sometimes these jobs can be made easier with the aid of a cheap wrench
that has been customized with a bench grinder.
On Sat, May 31, 2003 at 03:34:34PM -0700, Dan DiBiase wrote:
> Trying to remove the heater valve from the '76 B in preparation for
> removing the cylinder head... Any tricks to getting the bottom bolt off??
> My standard 7/16 wrench doesn't fit well between the valve and the engine
> block... And I can't get a socket on it due to the lack of space between
> the bolt and the valve body... Short of cutting it down, any tips??
>
> TIA...
>
--
I've found something worse than oldies station that play the music I used to
listen to. Oldies stations that play the "new" music I used to complain about.
lrc@red4est.com http://www.red4est.com/lrc
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|