The pipes clip to the engine mounts on the late models. Your engine
mounts are different, so don't buy the mount. The earlier pipes are
held by a clip that is retained by a small bolt that screws into a
tapped hole in the block located just above the oil pan and just behind
the front engine mount.
You want to make your bend in the steel line on the rear carb down to
bottom of the heat shield and then forward to above the bracket and down
to match the front line.
Cheers,
CR
Menno Meijer wrote:
> Dear List,
>
> Thanks for the responses to my previous (SU overflow)
> question. I'm currently working on replacing the
> short rubber hoses by the long fuel pipes.
>
> Can anybody tell me how and where the bottom of the
> overflow pipes should be mounted? My suppliers cata-
> log shows a "engine mount" which can be used to attach
> those pipes to the engine. But they state that it is
> used for cars after '64. My car is a '63.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|