Hi list
I am pulling the engine in my 64 b. Likely has either never been pulled or a
hell of a long time.
I am looking for info on what to use to get the brass oil sensor out of the
cast iron block. I know ( hope) there are some new wrenches out their that
will do the trick better then vice grips. Any suggestions? I have liberally
applied liquid wrench. Don't want to damage the thing. I was thinking of
putting duck tape on the thing before I used the vice grips but not excited
about this approach.
Wes Smith
64 B
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|