On Wed, 30 Oct 2002 13:24:20 -0500, Ray Wygonik wrote:
>Any advice on anything out of the ordinary I might expect? Will I need a
>shorter drive shaft?
There are two lengths, but I think they are within .75" of each other.
I think you should be fine without replacing it.
>
>My clutch has not shown any evidence of wear but once I have the engine and
>transmission out is it worth it to go ahead and replace? How would I
>recognize normal wear from, you-should-change-this-now wear?
I have read that unless it is brand new, you should just replace it.
That will give you however many miles you have already gone plus what
is left on it until you have to pull the engine again. You can get a
stock one for about $100. If you don't have an engine puller, renting
one will cost you at least 50% of that around here...
--
Andrew Lundgren
lundgren@byu.net
http://www.Lundgren.us
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|