Re: Replacing floor boards and other things

[Bullwinkle <yd3@nvc.net>]

I used a spot weld cutter.  It's similar to a small hole saw
with a tungsten carbide centering pin.  After removing the
rotted metal, you have to grind off the "nibs" left behind
where the spot welds were.  The depth of cut is adjustable,
so there's is practically no damage to the remaining panel
if you're careful.  I used it to remove all of the sills and
parts of the pillars on an MGA body.

Blake

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive