yesterday, I tried to put the poly sway bar bushes on.
AFter fighting it for a while. I take a look at them. The
hole is 9/16 and my bar is, of course, 5/8.
Since the old ones were ok. I reinstalled those. This was
more of an upgrade thing.
So what to do next? Can I drill the holes out? Are 5/8 bushes
available in poly? What is the size of the rear anti-roll
bar? Could I use them back there?
Oh, and Skye, heating the stuck pin worked well. Thanks for that. As a
side trip, finding by BenzOmatic cost me a couple hours to clean the
shelves in the garage. That was badly needed. :-)
Paul.
'77B
--
Paul T. Root E/Mail: proot@iaces.com
600 Stinson Blvd, Fl 1S PAG: +1 (877) 693-7155
Minneapolis, MN 55413 WRK: +1 (612) 664-3385
NIC: PTR FAX: +1 (612) 664-4779
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|