I am finally working on the MG again. I have a little dilemma though.
I purchased front and rear brake kits from Victoria British, along with
front and rear suspension bushings.
I got the wheels off. I also removed the bolt that hold the rotor to the
hub. How do I get the hub off?
I looked in the repair manual, and it says to take a cotter pin out through
the hole in the spline. There is no pin there.
I look in the center of the hub, and there is a bolt, with a metal covering,
but no way to remove that either. I am stuck.
Once I get the hub off, then it will make the suspension a little easier.
Thanks
patrick
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|