A quick question, my Bentley is at my car stored at my sisters for the
winter.
Last evening I replaced the 2 fuses in the fuse block, I pulled the coil
wire, checked everything (the Bay leaves trick Valerie told me about worked
'great' this winter !) crank it a bit-got oil pressure, replaced the coil
wire then it fired right up after 3 short cranks at full choke, it idled
right out in short order and the oil pressure was up around 60 psi. My
flasher makes all the blinkers (2 front+2 rear) work fine, and the red
flasher on the dash flashes, BUT when I use the left stem to operate the
blinkers-NO go ! and my brake lamps don't light.
any suggestions ?
should I start at the fuse block ? one of the bottom fuse holder tabs seemed
a bit flimsy.
Dan
68 MGB GT
in Massachusetts
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|