paul.hunt1@virgin.net wrote:
>
> Hmmm. If the pump was trying to draw current and you saw 12v at the pump
> terminals then the wiring back to the supply is OK and the pump wasn't
> pumping for some other reason. If the pump is trying to draw currenrt and
> there is a bad connection back towards the supply then you will
> significantly less than 12v at the pump, possibly nothing at all.
> Conclusion? Your pump will probably go AWOL again.
Thanks, Paul!
I would agree, but the "ifs" weren't satisfied in this case:
I saw 12 volts at the pump terminals with them *disconnected*.
The pump would not work when connected to the terminals, but worked
every time when connected to the battery terminals and is working
reliably connected to the new wires.
-Rock http://www.rocky-frisco.com
--
Red Dirt Rangers (Rocky on piano): http://www.reddirtrangers.com
JJ Cale Live (w/Rocky): http://www.rocky-frisco.com/calelive.htm
The Luggage Fan Club: http://groups.yahoo.com/group/luggage-fans
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|