Door switches were provided from the 67 'model year' so you should have them
already, it is normal to tap into the purple-white somewhere easy like by
the courtesy light for an alarm. The only way you will get at the back of
the A-post is to remove the front wing, but by removing the trim-panel it is
not that difficult to fiddle a wire from a hole in the A-post to the top of
the inner metal panel. The normal door switches either clip into the hole
or are secured with two screws from the front.
----- Original Message -----
From: "Wil Boucher" <william@greenmgb.com>
To: <mgs@autox.team.net>
Sent: Wednesday, February 06, 2002 4:43 AM
Subject: Kick Panel, quick question
> I was going to install my alarm today but got stumped and didn't want to
> go too far before getting some info...
>
> I want to put Door Switches in the A posts.
>
> In order to do that I need to drill holes in the A post and then slide
> in the switches, then I will need to access the rear of the switch to
> put a nut on and apply wiring.
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|