If the internals of the slave cylinder is not pitted, you might well get
away with replacing the piston rubber and before assembling have the
cylinder well polished internally.
Afterwards clean the cylinder with a kind of alcohol thouroughly. I worked
with me very
well and this saved me quite some $$$ or Euro's....
Cheers,
Hans
-----Original Message-----
From: paul.hunt1@virgin.net [mailto:paul.hunt1@virgin.net]
Sent: Monday, December 17, 2001 5:48 PM
To: Ryan, Wesley; 'Dan DiBiase'; Jerry Causey; MG Mailing List
Subject: Re: The famous Clutch!!!
Unless she is not one to be tangled with it probably just gave way. When
they break up inside you can get flaps that act like valves and these can
make the pedal hard. When I replaced my clutch hydraulics I used the pedal
to empty the m/c to make sure clean fluid was coming through the pipe, then
refilled the system using a Gunsons Eezi-Bleed on very low pressure from the
*slave* bleed nipple. That refilled the system in a few seconds, and it
didn't need bleeding at all. You are looking for about 1/2" travel at the
slave piston. If you haven't replaced the slave cylinder you should.
----- Original Message -----
From: "Ryan, Wesley" <wryan@giplastek.com>
To: "'Dan DiBiase'" <d_dibiase@yahoo.com>; "Jerry Causey"
<jcausey@whidbey.com>; "MG Mailing List" <mgs@autox.team.net>
Sent: Monday, December 17, 2001 1:39 PM
Subject: The famous Clutch!!!
> Ok Ok I know I have been working on my clutch now for weeks and still
can't
> get it to work right. I bled the clutch over the weekend and while my wife
> pushed the petal in; the rubber hose started to spray fluid. she also
> mentioned that the petal was getting tough to push. Does this sound like
the
> hose is bad or can it be something worse that caused the hose to break. It
> appears to me that you can't put the clutch in backwards because it won't
> slide over the spindle to the transmission. Am I correct? Regardless I am
> going to get a new hose I just wanted to know your thoughts.
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|