Morris,
This site may help...
http://www.cranecams.com/instructions/electronics.htm
Click on Installation Instructions. Be aware that they are in Adobe PDF
format.
Mike
'79B (Crane equipped)
----- Original Message -----
From: "Montgomery Morris" <mmorris@nemr.net>
To: <mgs@autox.team.net>
Sent: Sunday, September 23, 2001 1:01 PM
Subject: electronic ignition
> Thank you all for the info about the short that I'm experiencing. I've
> ordered a new ignition switch and Crane electronic ignition. Are the
> instructions for installing the Crane ignition fairly explicit (can a
> non-mechanic understand them) or will I need the list's help? Do I
> completely remove the old electronic ignition, which is attached to the
> distributor on the block side? I read somewhere that I'll need to bypass
> some resistor after installation, is this a slender "do-whicky" about
three
> inches long and half an inch wide that sits on the fenderwell with two
> wires coming out of it?
> Thanks, I hope this allows me to get back to DRIVING instead of
REPAIRING!!
> Monte,
> 79B
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|