I have a B with small hole in rear panel (dogleg) just before wheel arch,
near the ground. I bought the patch panels, and I have the car up on a body
rotator so I have good access, but I dont know how to remove the existing
piece to put on the new panel. Can someone tell me what procedures I should
follow? I've heard that I need to get a device that makes a stepped channel
in the remaining metal after cutting off the bad part... assuming I can
figure out HOW to remove the bad part!!!
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|