Dave,
I have the nut off -- moved the steering rack slightly to make clearance for
the socket.
But the pulley does not want to come off -- any ideas?
Simon
----- Original Message -----
From: "Dave Munroe" <dave@munroe.ca>
To: "Simon Matthews" <simon_atwork@hotmail.com>
Sent: Sunday, July 01, 2001 10:30 AM
Subject: Re: How to remove crank pulley nut?
> Simon;
>
> You need to remove the steering rack bolts and one end of the steering
shaft
> at the u-joint. Then you can pull the rack forward enough to get the
socket
> on.
>
> Mark the spline before you pull the steering shaft back, to be sure you
get
> it back in the same spot so your steering wheel will line up again.
>
> The pulley will come off no problem; the nut may be another thing. Get
back
> to us if the nut won't come off.
>
> Dave
>
>
> ----- Original Message -----
> From: "Simon Matthews" <simon_atwork@hotmail.com>
> To: <mgs@autox.team.net>
> Sent: Sunday, July 01, 2001 12:44 PM
> Subject: How to remove crank pulley nut?
>
>
> > This does not seem to have been posted, so my aplogies for any
duplicates:
> >
> > I have just been out and bought myself a 1 5/16" socket and tried to put
> it
> > onto the crank pulley nut. It will not fit because the steering rack is
in
> > the way.
> >
> > Now what do I do?
> >
> > Simon
> > P.S. AM I going to need a puller to remove the pulley itself? If not how
> do
> > I get it off?
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|