Mike wrote;
Now, what is your prefered method of working in this area, do you split the
seam removing all the old metal then sandwich the new rocker panel between the
two panels and re-weld. Or do you leave this seam alone since it is structural
then modify the rocker panel to fit over this area and seam weld it on?
Mike,
when I did my MGB I did not split the seam in the back or the front. I plug
welded
my new rocker panel to the existing clean metal flange. It worked just fine.
John
73 MGB
01 Mustang GT
John Di Fede
Business Analyst
Cablevision Systems
38 Old Route Nine
Wappinger Falls, NY 12590
jdifede@cablevision.com
ph (845) 297.7376x63521
fax (845) 297.9364
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|