Here's a question that must have come up before.
My '76B turn signals were flashing at a labored 1 every 5 seconds left &
right. Turn the headlights on or brake lights and the rate decreased
drastically. So before I went through tracing and cleaning the bullet
plugs in the harness, I thought I'd replace the flasher relay first. It
was easier.
Now, the right side flashes fine and independent of headlights or brake
lights. The left side flashes about 100/s (well, 20/s). I'm almost afraid
of an epileptic fit. But then I flashed the high/low beams of the
headlight and it started flashing 'right'. Played around with this for a
few more times and it is repeatable as I described.
So, is there a way to get into the turn-signal/high beam switch to clean
it or do these symptoms mean it is time to buy a new $117 switch?
Bill S
'76B
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|