Hi Max!
The spokes are right now on a '65 Midget which I also own, so I know the
current condition of them. I'll be checking them out thoroughly before doing
any drastic changes. I like the look of the spoke better than the rostyle,
but may forego the look for the ease of maintenance. Will see.
I appreciate the help from everyone once again!
Sue
Max Heim wrote:
> First, you need to ascertain whether the "spoke" wheels you possess are
> bolt-on or center-lock. That is, are there 4 small lug holes distributed
> around the center of each wire wheel, in the same exact pattern as on the
> Rostyle wheels? Or is there merely one large central hole which on close
> inspection is "splined" -- that is, has a continuous series of small
> parallel ridges around the inner circumference?
>
> If the former, just jack it up and swap the wheels. If the latter, you
> need to replace all four hubs with the appropriate components. This may
> also involve replacing the entire rear axle -- at least it does on an MGB
> (I don't know about Midgets). Consult your Moss or VB catalog for a quick
> cost estimate on the parts required.
>
> Threads per inch refers to the pitch of the screw threads on the center
> locking cap, and is not a relevant consideration vis a vis the wheels
> themselves -- it is merely necessary to match the correct caps with the
> correct hubs (which you do not have as yet). I don't think number of
> spokes is an issue with Midget wheels, either, but if you are curious you
> can always count them. Sometimes there is a higher-cost, heavy-duty,
> wider optional wheel available that features a higher spoke count, but I
> wouldn't think it worth worrying about, unless you have a V8. You can
> look up wire wheels in one of the aforementioned catalogs to see what is
> available for Midgets.
>
> Also, be warned that "used" wire wheels might not be worth installing.
> You didn't mention how you had acquired them.
>
> IMHO...
>
> SueCallaham had this to say:
>
> >Hi All!
> >Have a new question (at least new to me). I can do
> >engine/interior/wiring stuff, but know nearly nothing about
> >wheels/tires. Actually avoid that most of the time.
> >
> >Anyway on to my question. I have Rostyle wheels on my '74 Midget ....
> >what do I need to do to replace these with spokes? Second part of the
> >question ... how do I know the threads per inch and number of spokes on
> >a wheel? Have a set of spoke wheels to use, but as I said am not of
> >much use in that area!! Any/all info is welcome and helpful!
> >
> >Thanks!
> >
> >Sue
> >'74 Midget
> >'65 Midget
> >'65 MG-1100
> >
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the red one with the silver bootlid.
|