Folks
Haynes - Restoration Manual by Lindsay Porter.
isbn 1 85960 - 607 - 5
Gives a great method - really clear - helped me enormously when i
replaced the bearings.
David
73 BGT
In message <3A0773DB.EDA88921@ici.net>, Bud Krueger
<bkrueger@ici.net> writes
>Try Haynes page 208, Chapter 11 Suspension and steering, Section 13, Front
>hubs
>- description, removal, dismantling and refitting. There's a simpler technique
>for refitting the shims, no dial gauge needed, but I can't seem to find its
>reference. Listers? There's a good chance that the shims that you take out
>may
>be just right for reassembly. Don't lose 'em.
>
>Michael Jose wrote:
>
>> I have a Haynes and looked, but didn't find it. What page is it on?
>> What are the shims for? Shouldn't it just be pulling the old out, putting
>> the new in with grease, and tightening to spec?
>> Please advise
>> I just got the bearings, inner and outer, and seals, anything I missed?
>> thanks again.
>> Mike Jose
>>
>
>Bud Krueger
>http://home.ici.net/~bkrueger/
>52TD
>77MGB
--
Dr David M McNaughton
Haddington East Lothian
Radio GM8 KOF
|