To: | spanlab@ceibo.entelnet.bo, mgs@autox.team.net |
---|---|
Subject: | Re: Bad Temp Sender III |
From: | Gonaj@aol.com |
Date: | Mon, 6 Nov 2000 07:21:36 EST |
Enrique; While working on my ,76 MGB this weekend I took a minute to check the temp sender. It measured 1140 ohms at ambient 60 Degrees F and 80 ohms at temp w/ a 180 degree thermostat. I also measured 10 V on the lead connected to the sender. I normally run with the gauge just lower than dead center. The needle usually rests on the left leg of the N on the face of the gauge. I hope this is some help. George |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: No MG-American topical-NOW UK-specific, mup1dm |
---|---|
Next by Date: | Re: "Please don't kill me.", Gonaj |
Previous by Thread: | Re: No MG-American topical-NOW UK-specific, mup1dm |
Next by Thread: | Bad Temp Sender III, E.Claure |
Indexes: | [Date] [Thread] [Top] [All Lists] |