I think you need something useful to occupy your time. hehehehehe
Walt Goddard
waltcpa@sierra.net
----- Original Message -----
From: Larry Colen <lrcar@red4est.com>
To: Michael Singleton <one_ton3@hotmail.com>
Cc: MG's <mgs@autox.team.net>
Sent: Thursday, September 14, 2000 10:53 PM
Subject: Re: Timing marks
> On Thu, Sep 14, 2000 at 09:30:28PM -0700, Michael Singleton wrote:
> > increments from somewhere around 5 inches to 6-8 inches or so. I
don't
> > actually remember, as I don't need them right now, and I didn't
know what my
>
> For general info, I just measured it at 5.125 (5 1/8) inches.
>
> Just for nerdly satisfaction, that works out to 5.125 * pi / 360 or
> 0.044724 inches per degree. If I were a little bit more nerdly
> I could figure out how to get my laser printer to accurately print
> that out.
>
> It wouldn't be quite so bad as the time I made a hexadecimal slide
rule
> though. http://www.red4est.com/lrc/hexslide.txt
>
> lrc
>
> --
> Million Monkey Software -
> Our code sucks, but you should see this thing we wrote called
Hamlet.
> lrc@red4est.com
www.red4est.com/lrc
>
>
|