Umm, you just take out and replace the four bolts, right? What's the
problem with that? Slide the seat all the way forward to access the rear
bolts, then all the way to the rear to access the front bolts. I manage
to use a 3/8 ratchet drive on all of them, and never considered it a
particularly difficult job. Sometimes I do it just to vacuum the carpets
(uh-huh, like every 2 or 3 years, whether it needs it or not <g>).
I suppose, since there are multiple sets of holes in the rails, that your
seats could be using a set of holes that is not easily accessible using
this method. Next time, try sliding the rails back and forth and choosing
a different set of holes. Note that this also moves the seat position
limits forward or backward in the cockpit -- useful if you or your
passenger are particularly tall or short.
...or perhaps 72 seats are considerably different from the earlier ones I
am familiar with.
Dave Wood had this to say:
>Question of those who BTDT. I just put in a new emergency brake cable and
>had to remove the passenger seat to unbolt the cable. Replacing the cable
>was nothing compared to getting the seat back in place. I managed, but I
>hope there might be a better way as I intend to recover my seats one of
>these days. I removed the four bolts holding the rails to the floor board
>to remove the seat.
>
>Thanks for any advise for the future.
>
>Dave 72 B
>
>
>
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the red one with the silver bootlid.
|