mgs
[Top] [All Lists]

Re: Checking valves (was What's going on with my distributor?)

To: "Jon" <a77mgb@yahoo.com>, "mgs list" <mgs@autox.team.net>
Subject: Re: Checking valves (was What's going on with my distributor?)
From: <paul.hunt1@virgin.net>
Date: Wed, 30 Aug 2000 19:22:23 +0100
That's what I've done, it should be OK if the point of largest clearance is
only a few degrees of rotation away from the exact 'rule of nine' point.

PaulH.

----- Original Message -----
From: Jon <a77mgb@yahoo.com>
To: mgs list <mgs@autox.team.net>
Sent: Wednesday, August 30, 2000 6:54 PM
Subject: Re: Checking valves (was What's going on with my distributor?)


>
> <SNIP>
> > the exhaust.  I have recently discovered on some
> > valves that if I set the
> > clearance on the exact 'rule of nine' point there
> > can be an even bigger
> > clearance a little way before or after that point.
> <SNIP>
>
> I've noticed the same on my "B". I guess it's not a
> stock cam. Is it best then to adjust the valves to
> .015 at the point where clearance is largest?
>
> jon
>
> =====
> This is my list only e-mail address and it may not be
> checked regularly. For personal messages, please try
> jonp@altavista.net which is normally checked Mon-Fri.
>
> __________________________________________________
> Yahoo! Mail - Free email you can access from anywhere!
>


<Prev in Thread] Current Thread [Next in Thread>