Well, 17" is very high - so high it is off the top of my chart. It should
really be around 15" with a stock setup.
I don't have a CB GT but my CB roadster and my RB factory V8 GT both exhibit
very similar shackle position and spring shape - the lower shackle pin is
about 5/8" behind the upper shackle pin, and the springs are almost flat.
This is with relatively new CB roadster springs and old GT springs.
Your checkstrap length seems correct from what someone else with a 73 has
said elsewhere.
It seems to me your springs either have too much arch or are too high a
loading. If you can bear to get a spring off, put it on a level surface
upside down and measure the distance from the top of the top leaf to the
ground and I will compare it with my RB roadster springs - again not an
exact match with yours but it should give us an idea if the arch is badly
wrong.
PaulH.
----- Original Message -----
From: Evangelos Makris <xirias@hol.gr>
To: <paul.hunt1@virgin.net>
Cc: <mgs@autox.team.net>
Sent: Thursday, August 24, 2000 12:33 PM
Subject: Re: chekstrap question & measurements
> Here's the measurements I got from my 1973 BGT with chrome bumpers:
>
> Rear ride height: 17.25" for the right side and 17" for the left side.
> Brand new Checkstrap length (hole centre to hole centre): 8.25"
> Bump clearance: 6.25"
> The rear springs have 7 leaves each and the rear shackles are slightly
inclined
> "rearwards" with the car on its wheels.
>
> The exhaust-to-axle clearance is about 1/2" and the handbrake cable chafes
on
> the exhaust tube as it passes over it. The point at which they cross is
where
> the exhaust tube curves upwards to enter the rear silencer box.
>
> So, is this OK? How can I put the new checkstraps in? The only way I can
imagine
> is to ask for someone to sit in the boot while the car is on ramps (I have
to be
> underneath to work) so the rear springs are a little bit compressed. All
> pointers are welcome!
>
> Regards,
> Evangelos
>
>
>
> paul.hunt1@virgin.net wrote:
>
> > The exhaust is *supposed* to go under the axle and so does the handbrake
> > cable.
> >
> > When the car is on its wheels there should be slack in the rebound
strap,
> > but you do have to jack under the axle some when the body is supported
on
> > axle stands to get the strap on its pins. How long are your straps?
> >
> > What rear ride height do you have? Have a look at the web site below
(click
> > 'Spanners' and 'Ride Height') to see how to measure the height and some
> > typical measurements from around the world. How does yours compare with
> > these? I have had RB roadster springs on my CB roadster and connected
up
> > the straps no problem. It looks like either you have very wrong straps
or
> > very wrong springs or the springs are incorrectly fitted or located.
Can't
> > go far wrong at the front eye, but is the rear shackle pointing
backwards or
> > forwards as it drops from the chassis rail to the rear eye? It should
be
> > backwards.
> >
> > PaulH
> > http://www.mgb-stuff.org.uk
>
|