Ken Waringa wrote:
>
> Last week I asked about air nibblers, and got a lot of good responses, some
> for and some against air nibblers. I guess what I really need to know is
> which air tool is best for cutting sheet metal (some rusted) from my cars.
I am a big fan of the air nibbler and use it most for cutting, but
it's almost useless for cutting metal off a car. It's only really good
on flat sheet, any ribs or corners hang it up.
I have always just used an angle grinder with a 45 thou disc to
cut stuff off the car, and the nibbler to make up the patch panels.
--
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
"Homer, the ceiling is not a safe place for a baby!" - Marge
|