What's this stuff about a 12 foot and 40 foot being too SHORT!!!?
Dan
On Wed, 2 Aug 2000 20:40:49 -0700, Max Heim wrote:
> Uh, doesn't Moss sell pre-cut-to-length kits? The brakes would be in the
> same locations on a C (obviously) -- unless the fittings are different?
>
> Tweedy, Todd had this to say:
>
> >
> >
> >
> >The rear end of the C is almost complete, and looking fantastic by the
way
> >She's re-sealed, repainted, new leaf springs, new (re-built) lever arm
> >shocks, new straps, new everything, and all that is left is to replace
the
> >break lines.
> >I appears the PO had replaced them before an used lines which where much
> >to long, thus lots of unneeded bends.
> >I would like to make it as clean as possible by using the shortest lines
I
> >can.
> >I picked up a 12' and a 40' yet they seem (with out bending them yet)
that
> >they will be to short.
> >
> >Suggestions????????????
> >
> >Thanks
> >Todd
> >69' MGC
> >
> >
> >
>
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the red one with the silver bootlid.
>
Dan Dwelley
77 Midget
Alexandria, Va.
_______________________________________________________
Say Bye to Slow Internet!
http://www.home.com/xinbox/signup.html
|