My angle drive looked fine when I removed it. And it turned fine. There was
some slight wear on the square rod, which must have caused it to slip at
the point where it connected to the transmission. But it wasn't readily
apparent at the time. I suspected the worse - that the problem was in the
transmission.
I just hooked up my cable direct to my OD transmission, just trying to make
sure there were no sharp turns in the cable. And the speedometer now works
after not working for about a year.
David
67 BGT
71 BGT
At 12:41 PM 6/23/2000 -0700, Max Heim wrote:
>Yes, that's true. Or I have an angle drive you could have for a nominal
>fee. Best make sure it's the angle drive, though. It should be readily
>apparent if you remove it.
|