mgs
[Top] [All Lists]

Re: Suspension Spring Compressor

To: "Charley & Peggy Robinson" <ccrobins@ktc.com>
Subject: Re: Suspension Spring Compressor
From: Max Heim <mvheim@studiolimage.com>
Date: Wed, 14 Jun 2000 20:40:55 -0700
I just mentioned it despite its shortcomings because relying on a jack 
alone seemed a little treacherous. I think others have mentioned chaining 
or cabling the spring to some other suspension member so that if the jack 
slips the spring doesn't rocket about the shop.

Charley & Peggy Robinson had this to say:

>Hi Max,
>
>  The kind of compressor you describe is what I found to be the most
>commonly available.  It works fine for MacPherson strut springs, didn't
>look like it would work well for the B.  The tool in the Bentley manual
>fits under the spring pan and grabs the spring, near the top, from the
>sides.  One uses it to compress the spring and then unbolt the pan. 
>Then one unscrews the compressor to relax the spring and remove it and
>the pan.  
>
>   I suppose I can use a jack and partly disassemble the suspension on
>the car, then pull the crossmember and finish the work on the bench. 
>I've pulled the entire suspension unit out of a B before.  It drops out
>quite easily.  
>
>  Thanks,
>
>  CR
>
>  
>
>
>  
>
>Max Heim wrote:
>> 
>> I rented one from a local outfit. It resembled a long threaded shaft with
>> two hook-like objects that could be run up or down by turning nuts. The
>> problem with this type is that it has to hook on the second turn of the
>> coil, if you see what I mean, since the first one is deep in the spring
>> pan. This barely gives you enough spring to compress. Combined with the
>> jack it worked OK, however.
>> 
>> Charley & Peggy Robinson had this to say:
>> 
>> >
>> >  Anyone have a recommendation for what type of compressoor works best
>> >for removing the front coil springs on a B?  I'm going to rebuild the
>> >front suspension onto another crossmember and plan to remove the entire
>> >assy from the car.
>> >
>> >  I know I could use a jack to remove the spring while the suspension is
>> >in the car but it seems to me the rub could be in aligning things
>> >correctly upon reassembly, if I do it that way.
>> >
>> >  TIA,
>> >
>> >  Charley Robinson
>> >  '69 B.
>> >
>> 
>> --
>> 
>> Max Heim
>> '66 MGB GHN3L76149
>> If you're near Mountain View, CA,
>> it's the red one with the silver bootlid.
>


--

Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the red one with the silver bootlid.


<Prev in Thread] Current Thread [Next in Thread>