I think you have to remove the propshaft and the drive flange from the
output shaft in order that the (special) bolts can clear the casing.
PaulH.
----- Original Message -----
From: Skye Poier <skye@ffwd.com>
To: MG Nuts <mgs@autox.team.net>
Sent: Tuesday, February 22, 2000 6:08 AM
Subject: Clutch Done!!
> - When reattaching the propshaft to the tranny, I almost stripped one of
> the bolts. I used some washers to shim the nut out so it could bite
> some "fresh" threads but I'm pretty nervous about it and I drove home
> really carefully. When I had the tranny out though, it looked like
> the bolts wouldn't have enough travel to be removed from the holes.
> Is that the case?? What's the solution?
|