mgs
[Top] [All Lists]

Re: A-Arm bushings

To: mgs@autox.team.net
Subject: Re: A-Arm bushings
From: JTPAKI@aol.com
Date: Sun, 23 Jan 2000 19:11:35 EST
n a message dated 1/23/00 11:58:38 AM Pacific Standard Time, 
rrobertsmg@hotmail.com writes:

> Looks like I need to replace the a-arm bushings and seals in my 76B.
>  
>  With a good hydraulic jack to relieve tension from the coil springs, this 
>  job doesn't look too be much of a brain buster.
>  
>  Comments / Tips ??

Rick

I would not just jack up the suspension under the spring tray with a jack.  
The Lower arm must be disassembled to get them off the mounts and then 
replace the rubber bushings.  You really should use a coil spring compressor 
to get the pressure off the lower assembly.  The spring compressor type that 
will slip up into the small hole at the bottom of the lower spring tray which 
the for and aft arms mount to.  They are not very expensive, and the job 
would be much safer.

Joe Potter

<Prev in Thread] Current Thread [Next in Thread>